Plumbing

How to Protect Your Plumbing System From Freezing Temperatures

Broken water pies can turn into a very expensive and messy situation. Zen Kuchen reports that there are six main things that can be done in order to prevent pipes from freezing during cold weather.

Keep your heat on

If you will be away from your house for a long period, then make sure that your temperature is set at 55 degrees or higher.

Let your faucets drip

This helps to relieve pressure on the water system of your home.

Keep your interior doors open

When you leave, cabinet doors open it lets heat coming from the rest of your house keep your pipes warm.

Seal up any holes and cracks

Searches for places on the outside and inside of your house where cold air may get around and in the pipes.

Add heating tape

Use special electric tape and apply it to the pipes directly.

Add extra insulation

Fibreglass sleeves and foam rubber may be placed on pipes directly to help insulate them from cold weather. It is especially important to do this for pipes in basements and attics.

You only need to leave one faucet dripping, but it has to be in the right place. If you know where water comes into your home, turn a cold-water faucet on at the other end. So that water will travel throughout the whole system.

The Following Tips Come From the Red Cross. Do the Following to Ensure That Your Pipes Don’t Freeze and Create a Huge Mess:

Remove, drain and store your outdoor house and make sure that the inside valves are closed that supply the outdoor hose bibs. Your hose should be disconnected and the outside valve should be left open so that any water that is left inside of the pipe will be able to expand without the pipe breaking.

A pipe sleeve may be used like the ones that home repair stores sell or you can use heat tape or another type of specially made product for protecting exposed water pipes. Newspaper can even provide some protection and insulation for exposed pipes.

Check for any other areas around your home where supply lines might be in unheated areas. Search under bathroom and kitchen cabinets, the garage, attic, crawl space, and basement. You should insulate both the cold and hot water pipes in those areas.

If the garage has water supply lines, keep your garage doors closed.

Whenever it is very cold outside, allow the cold water to drip from the faucet that the exposed pipes serve. When water is run through the pipe, – even just a trickle – it helps to prevent the pies from freezing.

Have your thermostat set at the same temperature both at night and during the day.

If you turn your faucets on and no water comes out, then the pipe might be frozen. If that occurs, leave your faucets turned on and then call a plumber right away. If you think, you have a burst pipe, turn the water off at the main shut-off valve for your home, but leave your faucets turned on and then call the plumber.

How to Thaw Out Frozen Pipes

Keep your faucet open. While you are treating the frozen pipe and the area that is frozen begins to melt, water will start flowing through the area that was frozen. Running water through the previously frozen pipe will help to melt the ice inside of the pipe.

Seal all leaks that are allowing cold air into your house where the pipes are. It can be a problem around pipes, dryer pipes and vents, and electrical wiring.

Apply heat until the water pressure is fully restored. If you cannot locate the area that is frozen, or it isn’t accessible to you, or you are unable to thaw out the pipe, give a licensed plumber a call.

Check out your entire home is other faucets to determine whether you have any more frozen pipes. When one pipe freezes, other ones might also freeze.